Planning for a hurricane
Boaters should develop a well-thought-out hurricane plan before the hurricane season begins on June 1. Know where you will keep your boat and whether it can be hauled before a storm. Bring home trailer boats early, as evacuation traffic might prevent you from getting to your marina if you wait.
Once a hurricane warning has been issued, remove anything that causes windage and tie your boat with extra lines. Make sure you have extra rope, chafe guards, anchors and fenders (Don’t count on them still being on West Marine shelves.) Find out what your marina’s hurricane plan is before the season starts—does your dock contract call for you to take certain steps?
Hurricane watch
Take action during a hurricane watch, which is issued 48 hours before expected landfall. If you wait until a warning is issued, you may not have time to move your boat, and your storm preparation will be hindered by evacuation congestion. The storm’s outer bands of rain and wind can also hinder your efforts.
Follow the tips below to prepare your moored boat to weather the storm.
Remove your boat from the water if possible.
If your boat is trailerable, remove it from the water. Smaller, open boats and high performance powerboats with low freeboard will almost always be overcome by waves, spray and rain. Fortunately, most of these boats can be placed on trailers and transported inland.
If your boat isn’t trailerable, have it hauled out and secured on shore if possible. A Massachusetts Institute of Technology study after hurricane Gloria found that boats stored ashore were far more likely to be saved than boats stored in the water.
If a haul out isn’t feasible, follow these suggestions to give your boat the best chance of weathering the storm.
Charge batteries and disconnect the electricity.
Make sure to charge your batteries so bilge pumps will work. Disconnect the electric, water and other dock connections, and shut off fuel lines and close through-hull fittings. Cap off or plug unvalved through-hull fittings, such as sink drains.
Protect your engines.
Water will find a way into every opening, so protect your engine by covering engine room vents and plugging the exhaust pipes at the stern.
Remove loose deck items.
Remove deck items, Bimini tops, plastic, canvas and Plexiglas from the boat entirely. Take down antennas and remove outriggers. Remove as many items as you can from the boat, and lash down any remaining loose items.
Prepare the boat’s interior.
If your boat has a cabin, remove all loose items. Clean out the refrigerator, cabinets and drawers, which may open with the boat’s violent motion. If possible, remove drapes, cushions, mattresses and other cloth items that could become soaked from leaks.
Remove electronics and cover instrument gauges.
Remove electronics from the boat and cover both the holes and instrument gauges with plastic and duct tape.
Seal windows, hatches and doorways.
Because wind-driven rain will enter the boat through any crack or crevice, use duct tape to make all openings and seams as watertight as possible.
Secure the boat in its moorings.
Any boat in the water should be secured in a snug harbor. (Don’t even think about riding out the storm at sea unless you’re the skipper of an aircraft carrier.) The trick is deciding which harbors will still be snug and which will be vulnerable if a hurricane comes ashore.
Storm surge—high water—is a major consideration. A storm surge of 10 feet or more is common in a hurricane, so a seawall or sandy spit that normally protects a harbor may not offer any protection in a hurricane. A boat facing into the wind will best weather the storm, so if you can, turn the boat with its bow to the wind in the mooring.
Follow these steps to secure the boat in the mooring:
- Use mooring lines a quarter-inch larger to double the diameter of your current lines, and double all the mooring lines on your boat, including spring lines.
- Distribute the load evenly using several cleats. Make your boat look like it’s inside a spider web.
- Allow enough line as possible for the tide and storm surge. Rig crossing spring lines fore and aft and attach them high on pilings to allow for the tidal surge. Spring lines are best if they are at least as long as the boat. If possible attach longer lines to pilings outside your normal berthing area.
- Protect your line by using chafing gear at each point where the line meets the boat. Use several feet of garden hose or leather, and consider that your lines will be angled downward as the water rises.
–Al Ponzio

Weather the storm
Are you ready for the next hurricane? Learn how to develop a plan to protect your boat by taking our online seminar, Hurricane Preparation for Boaters.






